The Chamfer with Detachable Drip Edge is an important part of the Victory Bear chamfer system. This nonstick PVC form provides a smooth and straight chamfer and drip edge for door windows, dock doors and archways. The drip edge is detachable for custom placement. You will save time and labor costs with better-looking results every time.

Benefits

• Easy Installation - One installation forms both the chamfer and the drip edge in one easy operation.
• Custom Drip Edge Position - It’s easy to remove the drip edge and reposition it at any specified depth.
• Less Edge Seepage - Reduce the cost of clean-up. The seal fits tightly, preventing concrete seepage. Minimal patching, sacking and grinding on finished surfaces.
• No Form Release Needed - You save the cost and mess of form coat since PVC does not need a bond breaker.
• Better Looking - The use of PVC eliminates pock marks, rough edges and imperfections caused by wood. Eliminates discoloring of concrete due to wood sugars.
• Reusable - PVC is reusable, making your investment pay off many times.
• Cleans Up Easily - Victory Bear chamfers are made with PVC, an ideal material because it cleans up so easily.

Dimensions

Installation

1. Decide the placement of the drip edge. If the drip edge needs to be located deeper than the attached depth, cut along the scored edge with a sharp blade. Break the part along the scored line and set the drip edge aside for later.
2. Turn the opening form (i.e. window) upside down
3. Measure the VB Plastic chamfer length to fit the top of the form.
   
4. Miter the VB Plastic chamfer ends and attach the mitered parts to the wood form using fasteners or adhesives.
5. If necessary, measure, miter and install the drip edge at the required location.cide the placement of the drip edge. If the drip edge needs to be located deeper than the attached depth, cut along the scored edge with a sharp blade. Break the part along the scored line and set the drip edge aside for later.
   

**No Form Coat or Bond Breaker is necessary

Coefficient of Linear Expansion: .0132 inches per degree F

Storage: Materials should be stored out of direct sunlight to prevent long-term deterioration or color fading. Pieces can be stacked, but should be stored fully supported to keep them from warping.