 |
1
Set your string line up to your required height and position.
|
 |
2
Cut the first Top Strip in half, so Top
Strips will overlap the seams in the K-FORM beams. Then, attach to
first K-FORM beam, and fit end clips. |
|
3
Place spots of bedding mortar on the
sub-base at intervals of 311/2"
to
correspond
with the holes in the base of K-FORM beam.
|
|
4
Place beam on mortar and gently tap down
with a rubber mallet so that the Top Strip is at the desired level.
|
|
5
Place bedding mortar as above for the
next K-FORM beam.
|
|
6
Join the second K-FORM beam to the first
beam with the end clips.
|
|
7
Fit the length of the Top Strip across
the K-FORM beams.
|
|
8
Tap down the K-FORM beam as shown.
|
|
9
Once the forming system has been staked
and/or the bedding mortar has cured, you can start pouring concrete.
|
|
10
Each 8-foot K-FORM beam has pre-drilled 7/8"
holes
for
dowels.
|
|
11
K-FORM beams are cast in place,
therefore adjoining bays can be poured quickly, one after the other.
|
|
12
When the concrete has cured, remove the
Top Strip and fill the gap with sealant. Or, the Top Strip can be left
in place if preferred.
|
